Chastity Noob seeking help with device falling off.

[RAM_Bunny]

Well I fiddled with my CB some more and I've come to the conclusion that I can't wear it at all and beyond that I'm probably going to have to buy a steel device. I finally managed to squeeze down a ring size to where it quits slipping off but now it cuts off circulation if I get even remotely aroused in the cage. Blue Balls are one thing but LITERALLY BLUE JUNK no thanks I'm pretty sure that's dangerous.

Lady M: You asked about my measurements, I'm definitely a grower at 7in hard, but soft its 3 to 3 and half inches long with a 5 and 1/4 inch circumference

slave4missP & TwistedMister I've heard of the KSD for CB Cages and the more I look at them the more I think with my girth I'd have some serious issues getting my device on and off so I think I'll avoid that route.

Tame Lion - You're probably right about that, the only thing I worry about is that with a custom device if I measure wrong I just spent $300+ on a device I can't wear.

[Tame Lion]

Tame Lion - You're probably right about that, the only thing I worry about is that with a custom device if I measure wrong I just spent $300+ on a device I can't wear.

Custom devices can be adjusted at reasonable prices. The key dimensions you want to try to get right the first time are: cage diameter (not adjustable) and cage length. Your size isn't that unusual. I would very carefully remeasure your diameter and length. Mature metal will change ring diameter for $20. The more you get right in the beginning, the better.

[Michele]

Hey, with your 1.75" diameter you will have a tough time finding an off the shelf device... they aren't usually that wide which is an issue we had. If you are between 3&3.5" long soft you might need a custom one or to search around for a knock off steel device to see if that works that has the right measurements, or close!

I'd look for something that is at least 1.75" diameter and 3" long tube... you'll need to know your ring size too. I'm not sure you'll find it but you could have a look. We started with the Bird Cage but it's tube is longer than that.

Dhgate has a lot of devices fairly cheap which might help with finding a size that fits. Or... get a full belt haha that would lock up that cock nice and tight

[Wetnight]

We have a slipping forward issue but that is just something we have to deal with. Hubby has to be able to get a ball through the ring without pain and to do that it means the ring is juuuuuuuuuust too big so it does hang away from his body about an inch I'd say.

So I'm glad to hear that some slippage is normal. My Steelworx pulls away form my body a little (3/4-1 inch) and I was concerned, but it's never enough to risk my stuff from pulling out. I know that Steelwork makes a ring that slips on over the penis up to the base and this can help alleviate the risk of pull out and I may investigate getting that if I don't have to send the device back to get one.

I hear the piece about the ring, I may try a smaller ring in the future, but I'd like to get used to this one first and it is tight to get a testicle through it as well as I did with the CB6000S because that was open at the top.

Regards,

W