- PA mods to Jail Bird
- jail-bird-cut-bar-2.jpg (42.24 KiB) Viewed 3708 times
These mods were done to make the wearing of a PA more comfortable.
I have some experience of wearing a PA inside plastic devices and did not want to have to suffer the same cramped discomfort in the new JB.
Unless the PA has 'somewhere to go', it's going to get folded back inside the device and this can be not only uncomfortable, but painful, especially when the penis get's hard inside the cage.
I had William at MM cut away the bottom horizontal bar of the cage. The cut ends were then welded to the vertical bars. This created a long, vertical rectangular gap in the bars through which my PA could hang naturally.
William suggested that we might need to cut away the top horizontal bar as well as I sometimes wear quite large diameter PAs. To cater for this I asked him to weld the top horizontal bar to the upright bars but NOT to cut it.
This meant that at a later date should I need to remove this centre section of the top horizontal bar to create an even larger slot for a PA it could be done easily, and the welds would already be in place - I have the facility to cut stainless steel, but not to weld it.
The result works perfectly.
I wear a 5mm thickness PA most of the time, sometimes I wear a 6mm PA. Mostly the overall diameter of the ring is 16mm, but even my 19mm dia. rings drop comfortably through the gap created in the device now that the bottom bar has been cut.
I hope the pictures show the mods quite clearly. But please say if you need any more info.
I can definitely recommend this mod for PA wearers. With care, I can even change my PA ring while still in the cage. However there is just one small side effect.
The cage and the PA ring tend to act like a small bell and clapper and there is a just-audible chinking sound when I walk as the ring hits the cage. Mrs Ringo loves it. She can hear me coming and knows exactly where I am. I can hardly hear it at all.
