Jailbird Question

[beersuds]

Need advice with JB device. I have been wearing the CB6000s for some time now, and have decided to switch to a metal device. Was thinking about going with the JB, however I had a question about it and I am looking for some advice. Currently I am using the 1 3/4" base ring with my CBks and it fits perfectly. My concern is with the solid base ring with the JB. I feel like if I have to slip it on that it would be easy to slip out of, if that makes any sense. I would like to stay with the same size as I am using with my CBks, however I don't know if I can just slip it on with the 1 3/4" size and I really don't want to go any larger. I am open to any suggestions or would like to hear from anyone who wears the JB.

[Michele]

If you are comfortably wearing a 1 3/4 base ring now you should have no problem with the same in the steel ring. When getting into it you do one ball at a time and the squash the penis under and pull through. Things are squishy down there when not aroused so it works. If you really want to make sure order the sizing rings from MM and practice getting the 1 3/4 size on and make sure it works for you.

Hope that helps!

[Locked by LRC]

I would suggest the following. Either get a set of sizing rings or assemble the base ring without the cage. Then try to put the base ring on as a solid assembly as LadynMonkey described. This will ensure you can install it.

When I was using the CB series I was using the 1 3/4" base ring. The past experience with the CB2000's solid ring made me think this would be to small. When I ordered the fitting rings from MM I found my balls were still to large to fit through the 1 3/4" ring. I had to settle for the 1 7/8" base ring from MM.