Steelheart tube size question

[wspony]

Hi there,

you've propably read, that I have the new Steelheart since Saturday.

It features a 35mm diameter tube size. My penis measures about 29mm totally flaccid without the PA. I talked to Dietmar from Steelworxx and he suggested using not the 31mm tube because the PA-fixing would require some space as well.

With the 35mm tube my head fits very well with the pa-fixing laying along the glans. So this seems good. 31mm might compress my glans with the pa-fixing... However around the shaft there is quite some space and I noticed, that when totally flaccid I can put my little finger inside the tube and push forward to the glans.

At first I thought I could stimulate myself like this, however when I grew aroused, my finger was practically crushed against the device and the A-ring also dug into my finger. I could hardly move it anymore (if at all), so the stimulation was not much at all and the added finger in the aroused state was also enough to belittle the blood flow to my balls and penis and it started hurting so I pulled out my finger quickly.

My question to all you Steelheart wearers is now the following. Do you have similar sizes eg. can you put in a finger when totally flacid?

[Atone]

Not in the 31mm tube, yes in the 35mm tube.

[wspony]

Hey Atone, thanks for the reply!

But does the PA-Fixing or anything else interfer with your penis/glans/etc. in the 31mm tube? If I may ask, what is your diameter? So, you had a 35mm tube and now own a 31mm one? And like the 31mm one better?

As for length, does your flaccid friend fill out the length during normal wear or is there some space in the front? My fear with a longer tube always was, that it could slip down far enough (depending on your sac) to pull on your piercing all the time... which I don't think would be good.

[Atone]

Sorry I don't have a piercing but I do have the fixing for one for the 35mm tube and I have a fixing with penis plug also for the 35mm tube.

Yes, I like the 31mm tube better and I fill it to the end almost all the time. There is no extra diameter and no way a fixing with penis plug wood fit. The piercing fixing might fit but there would probably not be room for the ring. If I could get in it though I doubt I would have a problem with pulling. The 35mm tube that I use is also very short, even when flaccid there is no extra length. I am still hopeful that my wife will approve a piercing someday so I can find out for sure.

I am a fan of a short tube and would rather deal with some occasional poking at the tip than extra space.

[wspony]

Thanks Atone for the details.

This morning I also noticed that when totally aroused and desperate I can get some sort of stimulation by moving/shaking/rattling the device a tiny bit up and down. I think this is something that is possible in all CB devices. Even when ultra-tight I think when your cock is oily you can slide the metal just a tiny bit up and down over your cockhead. Do you experience/try this with the 31mm tube as well?

[Atone]

Do you experience/try this with the 31mm tube as well?

I don't know if I ever tried it with the 31mm tube.

With the 35mm tube there have been times that I could do that and get some stimulation that would probably lead to an (unsatisfactory if not ruined) orgasm. This was from stimulation of the base of the penis behind the rings. Once I attempt to get an erection the device is pushed out so far that I can get a couple of fingers around the base. Usually there is no pleasure in this but sometimes when the mood is just right it feels good.

Most of the time though everything just gets so tight that there is then no longer any stimulation.