Steel chastity and ball weights, compatible?

For the gearheads in the audience
George Lewis
Posts: 8
Joined: Sun May 25, 2014 3:58 pm

Steel chastity and ball weights, compatible?

Post by George Lewis »

I am quite new here, since the weekend, and this is my first posting outside the 'Hello' forum, so please bare with me and guide me if required. I am not even quite sure if this is the relevant place for this post.

As I mentioned in my Hello to this wonderful forum, I am back in chastity, self imposed at present :cry: and wearing a little known Mystic Public Enemy number 1 device. It is wearable for the approximate 12 hours per day that I can be locked up, but I have already ordered my next device, a Bon4M Small and am impatiently awaiting it's arrival. I have at the same time ordered a 15mm high ball weight/stretcher similar to:

http://www.bondara.co.uk/stainless-stee ... stretchers

I would like to wear both together during the time I can be at present locked up, and was wondering what experience, if any, anyone had of this combination, I am not even quite sure if I will find them compatible until I can try them.

I also wear a medium size jewelled steel plug of a similar design to this one:

http://www.top-to-bottom-leathers.co.uk ... t-Plug.htm

This I can wear for longer periods as it is very difficult to be seen or felt. I own the large version too, wonderful, but not really wearable for long periods.

Anyway, thank you for reading this my first post. I do wish to become a very active member of this site.

george
User avatar
locked4her55
Posts: 2236
Joined: Sat Feb 25, 2012 10:23 pm
Location: Massachusetts, USA
Gender:

Re: Steel chastity and ball weights, compatible?

Post by locked4her55 »

Hey George,

Nice to hear from someone else here that will be wearing weights.

I have been stretching since last September and have several different sizes of these that I wear:

http://www.thechaingang.com/adult-adven ... eight.html

Have always been "High & Tight" and wanted to hang a little bit lower.

I find the 20mm is easy to wear all day long but will switch to a 30mm when I go to bed.

Best of luck with your Bon4M
Happily secured since 4/2010 :-)
Have worn CB3000, CB6000s, MM Jail Bird & Watchful Mistress,
DHgate A271 & 273, DHgate Full Stainless Steel Belt & DHgate HT nub
Currently wearing A273
George Lewis
Posts: 8
Joined: Sun May 25, 2014 3:58 pm

Re: Steel chastity and ball weights, compatible?

Post by George Lewis »

Hello

And thanks for your reply. You are fortunate to be 'owned' at present I can't be 24/7 unless away.

Not particularly wishing to hang very low, just think it will feel 'right' to have my balls locked away and also make slipping out nigh on imposible, I would think.

Do you know how wide the hole is on your weights?

I am already planning the purchase of my final cage and think that MM will get the business, could you give me any feedback as to the pros and cons of Jail Bird versus Watchful Mistress and if you don't mind, the sizing you have?

I will let you know how my Bon4M Small goes when I get it next week - I hope!


george
User avatar
locked4her55
Posts: 2236
Joined: Sat Feb 25, 2012 10:23 pm
Location: Massachusetts, USA
Gender:

Re: Steel chastity and ball weights, compatible?

Post by locked4her55 »

George Lewis wrote:Do you know how wide the hole is on your weights?
I have two id sizes. Started out wearing a 38mm then went to a 36mm when I found under certain circumstances a ball would slip through.
George Lewis wrote:I am already planning the purchase of my final cage and think that MM will get the business, could you give me any feedback as to the pros and cons of Jail Bird versus Watchful Mistress
The JB was my first purchase from MM and I loved it. My wife also loved all the extra access she had of me. Hygiene was a big issue with the CB6000s and not at all with the JB. Problem for me was a rash that developed on my scrotum where it came in contact with my penis. This would occur after about a week or two. I asked MM if they could modify my JB by putting more stainless steel where the two areas came in contact. William said he was unable to accommodate the modification.

Looking at the design of the WM I saw it had a flat piece of stainless where I was having the problem. I now exclusively wear the WM for weeks at a time without any issues. Needless to say the WM is now my cage of choice.
George Lewis wrote:and if you don't mind, the sizing you have?
1 3/4" base ring
1 3/8" cage diameter
1 3/4" cage length
Happily secured since 4/2010 :-)
Have worn CB3000, CB6000s, MM Jail Bird & Watchful Mistress,
DHgate A271 & 273, DHgate Full Stainless Steel Belt & DHgate HT nub
Currently wearing A273
User avatar
Locked by LRC
Posts: 1034
Joined: Tue Jan 18, 2011 1:45 am
Location: Midwest, USA

Re: Steel chastity and ball weights, compatible?

Post by Locked by LRC »

You had asked in your Welcome post about my device; it's a custom design from Mature Metal.

I am intrigued with the E-stim part of your Public Enemy device.
I looked at it and it doesn't look like it come with a box. Is it an accessory item to an E-stim box?
Have you tried the E-stim part of the device?
Current device - MM Custom
Previous devices - CB2000, 3000, 6000, 6000s, Curve