steelheart length for the uncut

[hubby2nd]

Dietmar has got me a little confused regarding the length I need to order after I asked whether I needed to add any extra due to my being uncut and not wanting foreskin to protrude through the pee hole. I'm 55mm flaccid. Any advice gratefully received.

[hubby2nd]

OK, more specifically, I should ask what the measurement is from the outside of the A ring to the top of the tube, then I can give Dietmar the overall length of the device. The top gap is given as 5mm, but in his FAQ this is above the centreline for measurement of the overall length and also, I can't find the width of the A ring.

[poor]

The worse thing about our Steelheart is the occasional nip of foreskin through the pee hole. It doesn't happen often but every time is unpleasant.

I measured my average length over 3 days every time I urinated whilst wearing the tightest cock ring that would allow an erection to deflate. The ring pushes the meatus forward which lengthens the tube length needed. The cock ring was 8mm diameter and I ordered its size and I followed Dietmar's instructions on tube length. It worked out fine (the above notwithstanding).

We ordered the integrated lock (which I would heartily recommend but has a fugly huge key) so that set the gap. There are also several lengthy threads on sizing The Steelheart on this forum.

[hubby2nd]

Thanks. I took your advice and found a thread which indicated that the overall length of the device was the length of tube + 15mm, so I'll go with that and add 5mm to my flaccid length to avoid the foreskin sticking out the pee hole.