Upgrading Her Device - From CB6000s to ???

[LOCKEDnLOADED]

We have been using the CB 6000s (much to her delight) for the past month and a half. She likes me to be in the device more than out of it. To be honest, I feel strange now when its NOT on. Unfortunately, about a week ago while just sitting, my balls slipped out of the Ring and the device came off. I immediately reported this wardrobe malfunction, unlocked it and re attached it. It came off again in the shower later that same morning and I knew something had to be done. I went to the next ring down in size to "tighten up" the fit. This was (is) very painful. The pinching involved while assembling the CB brought me to me knees and my gasps made her almost (ALMOST) rethink the situation. After alot of bad noise, and alot of sweat, I was able to get it on. Wow did that hurt for a day. I got used to it but when the device had to come off for cleaning a week later, I had developed some nasty "Bite Marks" where the Ring was digging into me above my Penis.

(Breath)

All that being said, She suggested in upgrading to steel since she has no desire of going back to the way it was. Not that we had any problems, sex was great, but you guys know what i'm talking about. My question is, if we have one custom made, assuming we get the measurements correct, Would that perticular problem go away or does steel bring another type of issue. I'd appreciate any and all feedback as I truly want to do this for my wife but I dont want to spend $500 bucks plus just to run into the same roadblocks.

[TwistedMister]

The first thing to do, is figure out *why* your device came off. There are two adjustments for fit: ring size and spacer size. If you cannot go down a ring size easily, then try reducing the thickness of the spacer(s). I had almost the exact same problem recently- I was sitting here reading the board when I felt some discomfort. Within a few minutes the discomfort increased until it became pain, and then one of my nuts popped through.

Going down one ring size was not an option since that ring is broken and I have not mended it yet. Analysis of the situation determined that the plastic pins were just flexible enough that when everything tried to contract due to the cooler temperatures, there was just enough flex to cause the gap to increase slightly with the pressure from the contracting testicles and allow one to pop through.

Reversing the positions of the spacers I was using seems to have solved the problem- a thinner spacer between the base ring and cage reduces the gap, and allows less flexibility in the pins.

So, try that first before you go ordering metal.

If you order metal before finding out why you had the problem and what the solution is, you may still have the same problem only it will be much more expensive to fix. While it is true that you probably won't have a problem with the pin(s) flexing (unless you also experience discomfort in the presence of Kryptonite), you still need to be sure that you are getting the ring size and gap correct. Experiment now, while you can do it for free.

(I do not [yet] have metal, but reading some of the accounts here seems to indicate that some people are able to use smaller rings than they could with plastic. Ordering additional [smaller] rings in advance, with the device, seems to be less expensive than getting them later. Changing the gap size with a metal device appears to be a somewhat more expensive proposition.)

[LOCKEDnLOADED]

Great Idea. I will Adjust the spacer and Try again.

[Lockedup84]

I have the 3000 and actually went up a base ring size due to breaking the one down a size but in doing his I had to go down in spacer size as well. That fix my gal out problem hopefully for you too but the other option is a piercing which is the most secure way to go. Gl and find a solution before throwing money at a metal in hopes that it fixes it.