I can't get it in the tube

[joshyboy]

Hi all,

I just bought a CB6000. The base ring is very comfy but it looks like I have a larger than average penis and I'm really struggling to slip it in. I've tried using lubes and other moisturiser when it's most relaxed but it doesn't seem to work plus the fact that I'm uncut making it more difficult. I've read the sock method but I don't have any thin like/stocking sock. Any advice?

[Locked by LRC]

I think the sock method uses a nylon. Buy a cheap pair or a used pair if you have one available. You cut off the amount you need.

[Love2bLocked]

A variant of the sock method is to use a strip of plastic cut from one of the plastic bags stores use now.
Cut a piece about 12" x 12", wrap it around the cock, twist the end and insert down the tube. A little lube on the inside of the tube helps. Pull the cock into the tube. This is thinner than even nylons and usually slips on off the cock a little easier.

[poor]

My last tube was very close fitting. To get in it when not in the least bit aroused I did this:

1) Put your middle finger on the end of your glans and push it back into your body allowing the skin of your penis to envelope the finger up to the first knuckle.

2) With the other fingers (or the other hand) pinch the skin towards the finger and draw it out keeping the glans underneath the pinched skin.

3) Put the base of the tube over the glans and release the pinch. The penis will un-invert itself up the tube.

I'm not circumcised so I couldn't say if this will work for you but it got me into a 30mm tube every time.

[joshyboy]

Thank you guys! Appreciate it

[joshyboy]

Thanks guys you are amazing. Appreciate it!

[Chuck]

I also have a larger than average penis. Not huge, but above average. I also struggled to get my penis into my CB6000. I tried the stocking method and the stocking got wedged in and wouldn't come out. I ended up using lots of silicone lube and some wooden handled q-tip type swabs and sort of crow-barred it in. I then had to keep poking down the skin to try and get the cage to the ring. I finally managed to get locked in. I do hope it gets easier with practice. I may have to try the plastic bag trick that was mentioned if and when my Wife/KH lets me out.

I was really afraid I would break it open but after 8 days in it seems to be holding up rather well. I don't have any room at all to achieve an erection so it's doing exactly what my wife and I wanted from a chastity device.

I do recommend getting the cleaning kit from Kept for Her if you're going to be locked long term. http://keptforher.com/cleaning.html

[celticqueens_sub]

My cb 6000 split twice. Went to custom metal..... Fits exactly Never looked back!

[joshyboy]

I managed to get it locked in but now I can't pee! I don't know if it's just me or CB6000 is too tight. It is a very tight fitting there's no room at all and even spilling out a bit on those breathing holes. I was sitting on the toilet and I just can't urinate. It was desperate I had to take it off I really want to keep it on long term at least for a month or so but not able to pee is a massive issue! This is getting frustrating

[poor]

I had to wait until I REALLY needed to go in my 30mm tube. Now I'm in a 36mm tube I find that I have to go earlier or I end up backflushing the tube.