Does anyone work construction?

[TwistedMister]

Been a while since I was in a CB-6000S, but I seem to recall it not working while standing.

I don't think it's much different from the 3000 in that regard, and I've worked out a technique that is effective most of the time. First, apply good silicone lube before going out, so there's no getting badly stuck in an unusual position inside the cage. Carry an easily accessible Q-tip or [large] wooden matchstick (kitchen matches). Pull scrotum forward (if necessary) while pressing ring against body to keep tip at end of cage. Ensure alignment, use swab or matchstick if needed to 'poke' into place. Let fly.

This works *most* of the time for me...every now and then it goes a little haywire, which isn't a problem with the porta-potty standing urinal (you're close enough and the design is such that a little 'spray' isn't a problem) but can be messy if you're in a regular toilet stall and the distance is enough that you end up pissing on the floor or wall. If that happens, stop and poke until it's right.

This should work for most everyone if the cage is properly sized...unless one is cursed with a really tiny micro-dick.

[Sammysm]

Thanks everyone for the replies, I went back to work last week and everything was just fine, though I haven't worn a harness yet I'm sure that will be fine too. I didn't even notice the cage and no one else did either, which was one of my biggest worries. I was pretty nervous but with all your replies I gained the confidence to not worry about it at work. Thanks again guys

[poptart1200]

There is a certain amount of paranoia of being "outted" that associated with wearing a chastity device, but the truth is most people are too self absorbed about what others are thinking of *them* that they probably won't notice what you have going on down there.