Having met an absolutely scrumptious young lady of the Dominant persuasion, i find myself in need of a cage. Off to shop i went, thinking it wouldn't be a mission that would be difficult to complete.
Not long after measuring myself, i realized i was mistaken. Once upon a time, a doctor told me i have unusually large testicles which are unusually close to my body. Since he added that no health concerns would ensue, i paid it little mind.
With that in mind, here is the problem i hope to solve: my measurement for the cockring is 80.1 mm/3.28 inches. For the sake of this thread, let's assume that i got the measurement right, not only because i looked at instructions from many different sites and came up with consistent results, but also because the doctor foretold this. Let me also say that my other measurements are, shall we say, ordinary, such that they need not be a concern.
i have done some significant amount of shopping, and have yet to find a ring larger than 65 mm. Do i have to get my local blacksmith to pound a cage out on his forge?
All advice will be appreciated, and thanks.
Sizing Issues
-
- Posts: 2
- Joined: Tue Nov 01, 2022 6:46 pm
- Last orgasm: January 11th, 2024
- Gender:
Sizing Issues
0 x
- nosaint
- Posts: 250
- Joined: Sun Feb 09, 2020 3:03 pm
- Last orgasm: January 21st, 2024
- Orgasms this year: 3
- Gender:
Re: Sizing Issues
cherry keeper has a 80 MM ring
https://www.shapeways.com/product/XVL8P ... 7&li=shops
Personally, I like the Cherry keeper, I've been wearing them in various sizes, off and on, for several years
https://www.shapeways.com/product/XVL8P ... 7&li=shops
Personally, I like the Cherry keeper, I've been wearing them in various sizes, off and on, for several years
Last edited by nosaint on Sat Jan 27, 2024 8:12 am, edited 1 time in total.
0 x
Caged 24/7 since January 23,2024. Locked in a Cherry Keeper Micro
- Tom Allen
- Site Admin
- Posts: 5439
- Joined: Sat Sep 25, 2010 9:27 pm
- Location: Southern New England, USA
- Last orgasm: April 1st, 2018
- Orgasms this year: 0
- Contact:
Re: Sizing Issues
Typical cuff rings run from 40mm up to 60mm. Keep in mind that the ring should be snug against the skin, but not tight. Conventional wisdom is that one should be able to slide the tip of your finger under the ring.
To test if your measurements are correct, check Amazon for rubber O rings and buy some in a heavy gage (say, 1/8" or 6mm thick rubber) in the size you think you need. Be mindful that the O rings are usually sized by the outer dimension, so if you wanna 60mm fit, then you need to look at 70 or 75mm rings.
If it falls off, then you measured wrong.
Edit: something like this:
https://www.amazon.com/Othmro-70mmx66mm ... 48&sr=8-13
To test if your measurements are correct, check Amazon for rubber O rings and buy some in a heavy gage (say, 1/8" or 6mm thick rubber) in the size you think you need. Be mindful that the O rings are usually sized by the outer dimension, so if you wanna 60mm fit, then you need to look at 70 or 75mm rings.
If it falls off, then you measured wrong.
Edit: something like this:
https://www.amazon.com/Othmro-70mmx66mm ... 48&sr=8-13
0 x
Tom Allen
The Edge of Vanilla
Denial Permanente
The Edge of Vanilla
Denial Permanente