Stunning Steelwerkx Extreme Schandmaske
Posted: Sun Mar 27, 2016 6:51 pm
This is a stunning piece of Canadian engineering and workmanship, alas I have too many devices, so am doing some Spring-cleaning.
This Schandmaske piece is ultraminimialist and affixes directly to the end of your penis through your PA. No scrotal ring, no erection discomfort.
It's made out of titanium and is anodized - seems pearlescent blue and purple. Super light and comfortable! About as light as one of those polycarbonate pieces in total. I went minimialist/ locking coronal cap a while ago and never looked back.
The penile shaft area is 1" in diamter on the inside and 1" in length. The corona area inside is 1 3/8" across and 1 1/2 " in length.
The urethral insert part is much like a PA wand - the hollow tube is about a 1 gauge (bigger than a 2, but slightly smaller than a 0) and the PA pin is a 6 gague. Chris at Steelwerkx can remake this very reasonably if your sizes vary.
Two mated "s" keys and a locking "s" screw to keep it all firmly together.
Paid about $2,150. Make an offer....
This Schandmaske piece is ultraminimialist and affixes directly to the end of your penis through your PA. No scrotal ring, no erection discomfort.
It's made out of titanium and is anodized - seems pearlescent blue and purple. Super light and comfortable! About as light as one of those polycarbonate pieces in total. I went minimialist/ locking coronal cap a while ago and never looked back.
The penile shaft area is 1" in diamter on the inside and 1" in length. The corona area inside is 1 3/8" across and 1 1/2 " in length.
The urethral insert part is much like a PA wand - the hollow tube is about a 1 gauge (bigger than a 2, but slightly smaller than a 0) and the PA pin is a 6 gague. Chris at Steelwerkx can remake this very reasonably if your sizes vary.
Two mated "s" keys and a locking "s" screw to keep it all firmly together.
Paid about $2,150. Make an offer....