Transition to steel urethral tube Log.

[Mr Pickle]

Treat them as one unit once a lock nut has been used.

[Mr Pickle]

Year and a half update.
Never have I regretted this.
Quite the opposite in fact.

[Mr Pickle]

Bit of an update.
It's still in, has been every day bar a few since I started wearing it. Never an issue, not a twitch or redness. Nothing to indicate this type of urethral is anything but sage and clean. However.

I recently bought an identical unit and once assembled notice the urethral is not aligned the same way.
My original, the one I wear has the urethral positioned close to the bottom of the cage. Anatomically this is the correct place for it to be. Because your urethral in your penis runs along the bottom of your dick.
The replacements tube is centered so it would run through the exact center of your dick.
This simply will not work when yoi get hard, it would be painful.
I don't know why this change has happened, or if the original coincidentally has a fault that made it work?

But it is important to make sure the urethral tube is roughly where you actual dick urethral is. Along the bottom.

Cant show images because I'm wearing it, but will try to show the difference when this is not the case.

[waki86]

I also switched from a flexible urethral tube to a metal tube.
I also had no problems with either.
It slid in like butter.
I had done a lot of research in advance to determine which size would be best and how to best insert it.
The medical sites are also best suited for this.
It also explains what problems there may be and how to solve them.
If you take the right actions and take the right size.
There should be no complications and the urine should also be drained through the tube.
I also find it much more hygienic to wear a cage with a utethral tube.
It prevents unpleasant odors in your cage.
It also makes urination much easier.
The cage I have now, the steel tube is attached as a whole. In my opinion that is much better
No hassle with screwing in or the cap or nut coming loose.

[Mr Pickle]

I have altered the new cage so the urethral is in the correct position.
Basically I put a bloody big screw through the cage pee hole from the inside and used a crow bar.

Originally the urethral landed dead center of the ring which is quite likey where the manufacturer intends it to be, because even though they have a dick. They just haven't bother to look at it.

This photo shows my soon to be replacement cage and where it should be.

Then an actual medical pic showing as we all know, where the urethral is.

And then a diabolical picture of where the manufacturers think it is.

How? I mean when you take a pee you can feel it? You can see it? How have they got this so wrong?

[Mr Pickle]

It takes a bit of time to get used to having the insert, but all in all its not a bad thing depending on the actual diameter of the tube. I have a 7 inch UI in mine, if I am out of it for a day or two its a bit uncomfortable initially on reinsertion, but I get over that pretty quickly. If it is off only for shower / cleaning time, then reinsertion is easy and painless.

Up-thread you talked about an insertable end with like a washer to prevent urine from going down the sides of the tube. Was that an after-market thing, and if so where did you purchase it? I find that urine flows around the tube sometimes, and sometimes not. I'd prefer the "not" myself, makes somethings easier, like post bladder action cleaning.

Cumming in a UI equipped cage is unlike anything I have ever experienced before. More intense, less fullfilling, far different sensations. When/if your S.O. ever gets to that "evil" point you may never want to have her do you any other way. My S.O. and I are still discussing this possibility, and with luck and a bit of patience it should be something she enjoys as well.

Eddie